hood-filter.com is for sale — buy the domain, or the domain plus this complete website →

Calculator

Hood filter size calculator

Enter the width of the filter opening and the filter height. The calculator finds combinations of standard widths that fill the hood with the smallest gap.

Hood filter size calculator

How many filters fit?

Measure inside the filter channel, where the filters actually sit, not the outside of the hood.

Results appear here.

Assumes each filter's actual width is 3/8" less than its trade width. Gaps may need a listed filler or blank panel, so ask your hood manufacturer or local authority having jurisdiction. This is a planning aid, not an engineering specification.

How to measure the opening

  1. Shut down and cool. Turn off appliances under the hood and let the filters cool.
  2. Pull every filter and lay them out in order. Note any that are a different size.
  3. Measure the channel width from inside edge to inside edge, where the filters sit.
  4. Read the stamp. Most filters are stamped with their trade size on the frame edge, and the stamp beats a tape measure.
  5. Run the calculator and compare the result with the filters you removed.
Measuring a hood filter with a tape

Worked example

Take a 78-inch opening with 16-inch-high filters. Four 16×20 filters (19-5/8" actual each) cover 78.5", which is too wide. Three 16×20 filters plus one 16×16 cover 74.5", leaving a 3.5" gap. The calculator checks every mix of the widths you allow and ranks them by the smallest leftover gap. If even the best mix leaves more than about half an inch, ask your hood maker about a listed filler panel. Don't improvise with foil or cardboard.

Never run a Type I hood with a missing filter or an open gap. Grease-laden vapor bypasses the filters and loads the plenum and duct.

Sources

Frequently asked questions

Why is my 20-inch filter only 19-5/8 inches wide?

Trade sizes are nominal. The frame is made slightly smaller so it slides into the channel.

What if the result leaves a gap?

Small gaps may be closed with listed filler panels made for your hood. Check with the hood manufacturer and your local inspector.

Need a full set that fits the first time?

Send your hood opening or the size stamped on your old filters. We'll come back with matching sizes, quantities and options.

Get a quote
Size calculatorGet a quote